Se electronics dm16/29/2023 ![]() Providing a robust +28dB of gain, the DM1 is the perfect way to boost the signal from a passive mic, reduce the likelihood of interference, and provide significantly improved level to. If necessary, a cable can be used between the microphone and the DM1 - but the shorter the cable, the better the overall performance will be. The DM1 DYNAMITE is an active inline preamp intended to be inserted between a passive ribbon or dynamic microphone and a microphone preamplifier. A conventional solution is a pre-preamp, a phantom powered amp with a fixed amount of gain placed inline, usually as close to the source mic as possible. Reliable operation even in demanding on-stage applications in difficult environments is ensured by the roadworthy and slim all-metal design, robust construction, and high-quality manufacturing standards.įor optimum results, we recommend you plug the DM1 directly into your microphone's output. A new Pre-Preamp - sE Electronics DM1 Dynamite For folks using ribbons and other low-output dynamic mics, we often wish for more gain than we might have available in our preamps. Its output impedance is also the lowest in its class, allowing it to drive long cable runs while reducing susceptibility to RF interference, buzz and hum. Technical Specs for DM1 Dynamite Electrical impedance: 135 Ohms Load impedance: >1k Ohms Connectivity: Three-pin female/male XLR connector Power supply: 48V Phantom Power Frequency range: 10Hz to 120kHz Current consumption: 3.0 mA Gain: 28dB Max output level: 8. The DM1 DYNAMITE is an ultra-slim active inline preamp that fits. The DM1 is the perfect way to boost the signal from a passive mic, reduce the likelihood of interference, and provide significantly improved level to your preamp all without adding noise or coloration. sE Electronics DM1-MIC-PRE-U Dynamite Active Inline Microphone Preamp with 28 dB Gain. Additionally, the gain it provides is always a consistent 28dB regardless of the connected load, thanks to its dedicated buffer amplifier. ![]() With a sophisticated class-A design and specially-selected high-grade FETs, the DM1 has vastly lower output impedance and nearly half the noise of anything else on the market. The sE DM1 DYNAMITE is an ultra-slim active inline preamp that fits seamlessly between your mic and mic pre, providing a massive +28dB of clean, transparent gain for all your passive microphones. Some mics need a LOT of gain and not all preamps are up to the challenge. Explosive Level for All Your Passive Mics
0 Comments
Leave a Reply. |